Golf Pride CP2 PRO GRIP / - UNDERSIZE

Combining high-performance technology with a soft, tacky feel, the innovative new CP2 Pro® and CP2 Wrap® delivers comfort and control for superior performance. Featuring Golf Prides exclusive Control Core technology, a 2.5 inner core stabilizer is specifically engineered to reduce torque. A reduced taper design allows for even grip pressure in each hand, and a soft, high-traction surface provides comfort in every swing. With the CP2, control fits in the palm of your hand. Golf Pride CP2 Pro Grip - Features Undersize Grip Control core stabilizer technology that reduces torque by 41% when compared to same grip without core. CP2 is 31% softer than any other grip in the Golf Pride line. Reduced taper in lower hand to encourage light grip pressure. Improved comfort for golfers with arthritis +FREE GRIP TAPE INCLUDED WITH EACH GRIP STEP-BY-STEP REGRIPPING INSTRUCTIONS The following supplies are needed: 1.PRO-GRIP DOUBLE SIDED GRIP TAPE 2.STANLEY KNIFE / BLADE 3.NEW GOLF GRIP 4.SOLVENT WHITE SPIRITS 5.RUBBER GLOVES TO PROTECT HANDS 6. TOWEL / CLOTH STEP 1 - Remove the old grip with a Stanley blade Be sure to cut away from yourself at all times. Peel or scrape off the old grip and grip tape. Using a cloth and Mineral Spirits Grip Solvent, clean off the residue. *If removing a grip from a graphite shaft be careful to avoid damage to the shaft STEP 2 - Wrap your PRO-GRIP double sided grip tape in a spiral formation from the top of the shaft to the point where the bottom of the grip will be on the shaft. Remove the tape backing and cover the end of the shaft with extra tape. STEP 3 - Cover the vent hole in the butt end with your finger or golf tee, and pour a generous portion of Solvent such as white spirits inside the new grip. Close the open end of the grip with your hand and shake to cover the entire inside of the grip. STEP 4 - Pour the excess Mineral Spirits Grip Solvent (through the vent hole) over the entire length of the two-sided tape. Apply generously. Use a tray to catch excess Mineral Spirits Grip Solvent for use on other clubs. STEP 5 - Place the grip over the shaft butt and Push the grip entirely onto the club. Be sure to push it all the way down and align the grip as desired. This must be done while the grip tape is still wet. STEP 6 - Allow grips to dry for several hours before playing.